RAD ASMi-52 Especificaciones Pagina 39
- Pagina / 144
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
ASMi-52CD Ver. 1.0 Controls and Indicators 3-1
Chapter 3
Operation
This chapter describes how to configure the ASMi-52CD modem installed in the
LRS-24 hub using an ASCII terminal. It includes sections on:
• Initiating an ASCII terminal session
• Selecting command options
• Configuring the modem.
3.1 Turning On
To turn on ASMi-52CD:
1. Turn on the LRS-24 chassis and the modem on the far end of the line.
2. After power-up, all LEDs turn on for 3 seconds while the CPU initiates the
ASMi-52CD module.
3. After synchronization between the two modems has been achieved, the
ASMi-52CD module assumes the normal state according to the LED
indications in
Table 3-3
.
4. For other LED indications, see
Table 3-1
.
5. For troubleshooting, see
Using LEDs
in Chapter 4.
3.2 Controls and Indicators
ASMi-52CD 2-Wire
Figure 3-1
shows the front panel of the ASMi-52CD 2-wire module.
Table 3-1
lists
the functions of the ASMi-52CD front panel indicators.
- ASMi-52CD 1
- Limited Warranty 4
- Product Disposal 4
- Safety Symbols 5
- General Safety Instructions 5
- Handling Energized Products 6
- Attention 8
- FCC-15 User Information 9
- Quick Start Guide 11
- Configuring the Clock Source 12
- Contents 15
- Chapter 1 17
- Central Site 18
- Remote Site A 18
- Remote Site B 18
- Data Rate 19
- Remote Management 20
- 1.2 Physical Description 21
- Figure 1-4 23
- Figure 1-4) 23
- Table 1-5 23
- 1.3 Functional Description 24
- 1.4 Technical Specifications 25
- Chapter 2 27
- Installation and Setup 27
- 2.2 Package Contents 28
- Figure 2-2 29
- Warning 29
- Interface Module Inspection 30
- LRSI-F-24 31
- LRSI-F-25 31
- Figure 2-5 32
- Connecting the Line and DTE 33
- Figure 2-6. LRSI-F-5 34
- Figure 2-7. LRSI-F-14 35
- Figure 2-8. LRSI-F-23 36
- Chapter 3 39
- Operation 39
- Figure 3-1. ASMi-52CD LEDs 40
- ASMi-52CD 4-Wire 41
- 3.3 Turning Off 42
- Chapter 4 43
- Configuration 43
- Table 4-1. LRS-24 Screens 44
- Figure 4-1 44
- Table 4-2 45
- 4.4 Configuring the Modem 46
- Configuring the E1 Interface 47
- Chapter 5 49
- Troubleshooting and 49
- Diagnostics 49
- Figure 5-1 50
- Table 5-1 50
- Running Loopback Tests 52
- Running the LEDs Test 53
- Figure 5-4 54
- Figure 5-5 54
- Figure 5-6 54
- Table 5-3 57
- Table 5-4 57
- Table 5-5 57
- 5.5 Troubleshooting 60
- 5.7 Technical Support 61
- Appendix A 63
- Pinouts 63
- A.2 LRSI-F-14 64
- A.3 LRSI-F-23 65
- Figure A-4. LRSI-F-24 66
- Figure A-5. LRSI-F-25 67
- Appendix B 69
- Memory and Download 69
- B.2 Download Procedure 70
- Downloading via LAN 71
- Downloading via XMODEM 71
- Downloading via CM-2 Flash 72
- Figure B-7 73
- Appendix C 75
- List of Parameters 75
- Figure C-2 76
- Table C-2 76
- Table C-2. Modem Setup 79
- C.3 Displaying Modem Status 83
- Figure C-7 87
- Appendix D 89
- IR-ETH Ethernet Card 89
- Setting the DIP Switch 90
- General 91
- Installing Interface Module 92
- D.4 Connections 93
- Appendix E 95
- IR-ETH/Q Ethernet Card 95
- DIP Switch Settings 96
- E.2 Technical Specifications 97
- E.4 Connections 99
- Pin Assignment 100
- Appendix F 101
- IR-ETH/QN Ethernet/Fast 101
- Ethernet Card 101
- F.2 Application 102
- F.3 Technical Specifications 102
- Configuring IR-ETH/QN 103
- Installing IR-ETH/QN Card 105
- LED Indicators 106
- Fault Propagation 107
- Appendix G 109
- IR-IP Interface Card 109
- Application 110
- Physical Description 110
- G.2 Technical Specifications 111
- Cabling 112
- IR-IP LEDs 113
- Introduction 114
- Rescue Configuration 115
- Connecting the Telnet Host 116
- What to Do If 116
- General Operating Procedures 117
- Figure G-4. IR-IP Main Menu 118
- Figure G-5 118
- G.7 Quick Setup Menu 119
- WAN IP Address 120
- WAN IP Mask 120
- Default Gateway 120
- DHCP Relay 121
- Protocol 121
- G.8 Management Access Menu 122
- G.9 Advanced Setup Menu 123
- Interface Parameters Menu 124
- Quick Setup Menu 125
- Figure G-6 125
- Protocol Field Compression 126
- Authentication Protocol 126
- Multicast IP Menu 127
- Multicast Forwarding 128
- Static Groups 128
- G.10 Device Control Menu 129
- View Error Log Screen 130
- Erase Configuration 131
- Resets Menu 131
- G.11 View Menu 132
- Configuration and Connection 133
- ARP Tables 133
- Statistics Screen 134
- Using the Ping Function 136
- Customer Response Form 139
- Error Report 141
- Innovative Access Solutions 144
Relacionado con productos y manuales para Redes RAD ASMi-52
Redes RAD ASMi-54 Especificaciones
(64 paginas)
(64 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.027 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales